Tune-Ups & Maintenance
Most summer breakdowns we attend were visible months earlier. A tune-up is the cheapest thing you can do to a system.
Learn more
Heater and furnace repair in Roseville
A furnace that fails in December isn't only a comfort problem. We find the cause rather than the easiest part to sell you.
- 5.0 on Google
- Licensed & insured
- Open 7 days a week
- 0% financing available
Signs you need heater repair
No heat, or air that never gets warm
The blower runs but the burners don't light
A burning smell on startup that doesn't clear
Banging or rumbling when it fires
The unit short cycles
A carbon monoxide detector that has triggered. Leave the house and call 911 from outside
DIY first
How to fix a heater that won't turn on
Check the thermostat
Select Heat mode, set the target well above room temperature, and check the batteries.
Find the furnace switch
It looks like a light switch and can be knocked off accidentally. Make sure it is on, without opening the furnace.
Check the breaker
Only if the panel is dry and undamaged, switch the tripped breaker fully off, then on once. If it trips again, stop.
Check the filter
A badly clogged filter can trigger the high-limit shutoff. Replace it with the correct size and rating.
Check the condensate drain
Look for visible pooling or a blocked drain outlet. A blocked line can trip a float switch on high-efficiency units. Do not bypass it.
Look for a status light
Observe through the viewing window without opening panels. Count the flashes and quote the code when you call.
When to stop and call
- If you smell gas, leave immediately without operating switches. Call PG&E at 1-800-743-5000 from outside; call 911 for immediate danger.
- If a carbon monoxide alarm sounds, everyone must leave immediately and call 911 from outside. Do not re-enter until responders say it is safe.
- Burning that doesn't clear, scorching or soot near the burners means stop using the heater and call.
- The heater lights, then shuts down repeatedly.
How a heater repair visit works
- 1
Safety check first
Every gas appliance gets one regardless of what you called about.
- 2
Full diagnostic
We test the ignition sequence, not just the symptom you described.
- 3
Fixed written price
Explained before anything starts.
- 4
Repaired and tested
Full heat cycle, and combustion checked before we leave.
What heater repair costs
Most no-heat calls come down to an igniter, a flame sensor, a pressure switch or a control board. Those are parts, not systems. If we find a cracked heat exchanger or a combustion problem you'll be told plainly, and we won't restart a system that isn't safe to run.
0%
APR for 12 months
Financing provided by GreenSky
Questions about Heater Repair
Common. A furnace that sits unused for months often fails on first use. Check the thermostat, the service switch and the filter first. Our blog walks through it.
Related services
Full System Replacement
We'll tell you plainly when a repair is the better call. When it isn't, you get a system sized for this climate rather than a catalogue default.
Learn more
Licensed Inspections
Buying, selling, or just want to know what you've actually got. A licensed technician, a full assessment, and a report you can hand to someone else.
Learn moreHeater Repair service areas
Based in Roseville and covering roughly 45 miles around.
Serving these communities and the surrounding area.
- Heater Repair in RosevillePlacer County
- Heater Repair in RocklinPlacer County
- Heater Repair in LincolnPlacer County
- Heater Repair in Citrus HeightsSacramento County
- Heater Repair in Rio LindaSacramento County
- Heater Repair in Plumas LakeYuba County
- Heater Repair in AuburnPlacer County
- Heater Repair in FolsomSacramento County
